Tool Position Setting.

[ Új üzenetek · Tagok · Fórumszabályzat · Keresés · RSS ]

Oldal 1 / 1 1
A fórum moderátora: KisKZ, tweakie, Amatőr

Fórum » Only in English » Mach3 related issues » Tool Position Setting. (X - Y - Z setting.)

tweakie

Dátum/Date: Vasárnap, 2012-04-22, 06:56 | Üzenet/Post # 1

alapvető tag

Csoport/Group: Adminisztrátorok

Üzenetek/Posts: 1050

Kitüntetések/Medals: 6

Hírnév/Fame: 5

Helyzet/Status: Offline

Hi Guys,

Just a note to say that I have posted my implementation of ‘Tool Position Setting’ in the ‘Articles’ section of the main website here;

Part 1. - http://hobbycncart.com/publ....-1-0-30

Part 2. - http://hobbycncart.com/publ....-1-0-31

There are many different ways in which initial tool setting can be achieved and this just describes the method that I currently use. I hope this information may be useful to others and perhaps inspire an improved or easier solution.

Tweakie.

Success consists of going from failure to failure without loss of enthusiasm.

Fórum » Only in English » Mach3 related issues » Tool Position Setting. (X - Y - Z setting.)

Oldal 1 / 1
1